extractor tool for cmx receptacle connector doc no: ats-638240100 release date: 07-14-10 uncontrolled copy page 1 of 2 revision: e revision date: 06-06-12 figure 1 tpa se condary locking latches (both sides) extractor tool slots tpa secondary lock closed figure 2 lockin g latches open (both sides) extractor tool tpa secondary lock open slots extractor tool application tooling specification sheet order no. 63824-0100 features this extractor tool is for opening the secondary lo ck from cmx receptacle 53 way, 198009 series. this tool will also assist in closing the secondary lock. scope products : cmx receptacle connector assembly, 53 way, right an d left slide orientation. housing series no housing or der no. 198009 198009 - 1001 198009 - 1002 198009 - 1003 198009 - 1004 198009 - 2001 198009 - 2002 198009 - 2003 198009 - 2004 operation: opening the (tpa) secondary lock on a cmx receptacle assembly follow the steps below : 1. insert the extractor tool into the (2) side slots o f the (tpa) secondary lock on each sides until it s tops. see figure 1. 2. while keeping the extractor tool in this position p ull down on the sides of the (tpa) secondary lock w ithout touching the latches. the locking latches should b e visible. see figure 2. 3. remove the extractor tool and check the position of the tpa.
extractor tool for cmx receptacle connector doc no: ats-638240100 release date: 07-14-10 uncontrolled copy page 2 of 2 revision: e revision date: 06-06-12 locking latches open (both sides) extractor tool tpa secondary lock open locking latches closed (both sides) tpa secondary lock closed figure 3 figure 4 seal protected by a moveable skirt there should be a small gap between the bottom stop of the tool fingers and the tpa the tool fingers bottom stop should be in contact with the tpa before pushing on the tpa closing the (tpa) secondary lock on a cmx receptacle assembly, follow the steps belo w: secondary lock can be closed manually or during the final connector check. this procedure is done after the insertion of all f emale terminals. 1. insert the extractor tool into the (2) side slots o f the (tpa) secondary lock on each sides. see figu re 3. 2. push up on the extract tool until the tpa contacts with the edge of the seal and the locking latches c lick in place. 3. make sure there is no space between the tpa and the seal. see figure 4. 4. remove the extractor tool. note: one of the functions of the secondary lock (tpa) is to detect if any of the terminals are not fully se ated in the cavities. if the secondary lock does not close, re open the tpa. push on the terminals one at a time to make sure th ey are locked in place. close the secondary lock see step 2 and 3. check visually the locking latches are in the corre ct position. molex does not offer repair parts for extractor too ls due to the inexpensive nature of these tools. caution : molex specifications are valid only when used wi th molex terminals and tooling. http://www.molex.com
|
